CHAPTER 7 8-BIT TIMERS 50, 60, AND 61
User’s Manual U15331EJ4V1UD 121
(5) PPG output mode (PPG: Programmable Pulse Generator)
Pulses are output using any cycle or duty ratio (pulse width) set (both the cycle and pulse width are
programmable).
(6) 24-bit event counter mode
Operation as an external event counter with 24-bit resolution is enabled using 16-bit timer 20 and timer 61.
However, this mode operates only as a counter read function.
There is no compare, match, or clear function.
<Setting method>
<1> Select the timer 61 interrupt signal for the count clock of 16-bit timer 20 (TCL201 = 0, TCL200 = 0)
<2> Set timer 61 in stand-alone mode (TMD611 = 0)
Select the external clock input from pin TMI61 for the count clock of timer 61
((TCL612 = 0, TCL611 = 1) or (TCL612 = 1, TCL611 = 0))
<3> Set CR61 to FFH
<4> Read the current count value of 16-bit timer 20
(16-bit timer 20 does not have a count clear function and is counting constantly)
<5> Enable timer 61 count operation (TCE61 = 1)
Figure 7-1. Block Diagram of 24-Bit Event Counter
Internal bus
TMI61/TO61
/INTP2/P32
Timer readTimer read
Timer 61
(lower 8 bits)
Timer 20
(higher 16 bits)
Select external clock
for count clock Select timer 61 interrupt
signal for count clock