CHAPTER 7 8-BIT TIMERS 50, 60, AND 61
User’s Manual U15331EJ4V1UD
126
Figure 7-5. Block Diagram of Output Controller (Timer 60)
F/F
RMC60 NRZ60
TOE60
PM31
P31
output latch
Selector
TO60/INTP1/P31
Carrier generator mode
Carrier clock
(1) 8-bit compare register 50 (CR50)
This 8-bit register is used to continually compare the value set to CR50 with the count value in 8-bit timer
counter 50 (TM50) and to issue an interrupt request (INTTM50) when a match occurs. In PWM mode, this
register is used for high-level width setting.
CR50 is set with an 8-bit memory manipulation instruction.
RESET input makes this register undefined.
Cautions 1. In PWM output mode (TMD501 = 1, TMD500 = 0), if CR50 is rewritten while the timer is
operating, a high level may be output for one clock cycle immediately after this rewrite
operation. If this waveform may cause problems in the application, either <1> stop the
timer when rewriting CR50, or <2> rewrite CR50 after TOE50 has been cleared.
2. If both edges have been selected as the valid edge of the count clock in PWM output
mode (TEG50 = 1), do not set CR50 to 00H, 01H, or FFH. Also, if the rising edge has
been selected as the valid edge (TEG50 = 0), do not set CR50 to 00H.
(2) 8-bit compare register 60 (CR60)
When connected to TM50 via a cascade connection and using as a 16-bit timer/event counter, the interrupt
request (INTTM60) occurs only when matches occur simultaneously between CR50 and TM50 and between
CR60 and TM60 (INTTM50 is not generated).
In carrier generator mode and PPG output mode, the low-level width of timer output is set by writing a value
to CR60.
CR60 is set with an 8-bit memory manipulation instruction.
RESET input makes this register undefined.
(3) 8-bit compare register 61 (CR61)
This 8-bit register is used to continually compare the value set to CR61 with the count value in 8-bit timer
counter 61 (TM61) and issue an interrupt request (INTTM61) when a match occurs. In PPG output mode,
this registered used for low-level width setting.
CR61 is set with an 8-bit memory manipulation instruction.
RESET input makes this register undefined.