E–13
Operating Range Remote Control Battery Installation
1. Push to open the battery cover.
2. Remove both old batteries and install new ones (AA). Ensure
that you have the batteries’ polarity (+/–) aligned correctly.
3. Put the battery cover back on.
Do not mix different types of batteries or new and old batteries.
Remote Control Precautions
•Handle the remote control carefully.
•If the remote control gets wet, wipe it dry immediately.
•Avoid excessive heat and humidity.
•If you will not be using the remote control for a long time,
remove the batteries.
Note on Remote Control Operation:
Pressing and holding the Select ( , , , ) / Mouse but-
tons while installing new batteries may cause malfunction or no
operation.
Should this happen, remove the batteries and then install them
again without touching the Select/Mouse button.
NOTE: Do not change the settings of the function (DIP) switches.
There are two switches on the bottom of the battery case. For
normal operation, these function switches are not used. Be sure
to leave the No.1 switch at its original factory setting(OFF). Do
not change the setting of the No. 1 switch. Failure to do so will
cause incorrect movement in Select ( , , , ) / Mouse
buttons.
7m
30˚
30˚
7m7m
22feet
22feet 22feet
Function (DIP) Switches