E–28
Using the Menus
1. Press the “Menu” button on the remote control or the projec-
tor cabinet to display the Menu.
2. Press the buttons on the remote control or the projector
cabinet to highlight the menu for the item you want to adjust
or set.
3. Press the button or the “Enter” button on the remote con-
trol or the projector cabinet to select a submenu or item.
4. Adjust the level or turn the selected item on or off by using
“Select” or buttons on the remote control or the projec-
tor cabinet. The on-screen slide bar will show you the amount
of increase or decrease.
5. The change is stored until you adjust it again.
CANCEL: Return to the previous screen.
6. Repeat steps 2-5 to adjust an additional item, or press “Can-
cel” on the remote control or the projector cabinet to quit the
menu display.
Geometrical Correction
If the image is distorted or not displayed correctly on the screen,
do the following.
Raise the projector height using the adjustable tilt-foot.
Each of the feet height can be changed up to 1 mm or at angles
up to 1 degree.
Use keystone correction for proper adjustment. See page E-31.
Rotate the projector to make the image square to the screen.