1-8
30°
30°
30°
30°
Battery Installation
1.Press the catch and remove the battery cover.
2.Remove both old batteries and install new ones (AA). Ensure
that you have the batteries' polarity (+/-) aligned correctly.
3.Slip the cover back over the batteries until it snaps into place.
Do not mix different types of batteries or new and old batter-
ies.
Note on Battery Installation:
If you press and hold the SELECT 왖왔왗왘 button while install-
ing new batteries, the remote control may fail to work properly.
Should this happen, remove the batteries and then install them
again without touching the SELECT button.
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time,
remove the batteries.
• Do not place the batteries upside down.
• Do not use new and old batteries together, or use different
types of batteries together
Operating Range for Wireless Remote Control
7m/22 feet 7m/22 feet
Remote control
Remote sensor on the projector cabinet
• The infrared signal operates by line-of-sight up to a distance
of about 22 feet/7 m and within a 60-degree angle of the re-
mote sensor on the projector cabinet.
• The projector will not respond if there are objects between
the remote control and the sensor, or if strong light falls on the
sensor. Weak batteries will also prevent the remote control
from properly operating the projector.
Using the Remote Control in Wired Operation
Connect one end of the supplied remote cable to the REMOTE
mini jack and the other end to the remote jack on the remote
control.
PJ
HELP
POINTER
MAGNIFY
SLIDE
FOLDER
SLIDE
LIST
OFF
VIDEO
AUTO ADJ.
RGBVIE
WER
LASER
ON
POWER
SELECT
ASPECTFREEZE
3DREFORM
FOCUS
VOLUME
ZOOM
PIC-MUTE
PC CARD
AUDIO IN
R
VIDEO INS-VIDEO IN DVI-I IN RGB IN RGB OUT
DVI-I RGB
AUDIO INUSB AUDIO OUT
PCCONTROL
REMOTE
IN
L
/MONO
REMOTE
IN
1. Introduction
NOTE: When the remote cable is inserted into the REMOTE IN jack,
the projector's status is changed from the Standby mode to the Idle
mode.