6
1. Introduction
Opening and Closing the Mirror Cover
To open the mirror cover:
1. Slide the mirror cover lock switch to the unlock position.
UNLOCK
MIRROR
LOCK
1
2. Slowly open the mirror cover holding both ends.
UNLOCK
MIRROR
LOCK
2
NOTE:
•Do not release your hold of the mirror cover until the mirror cover
is fully open.
•Do not apply excessively strong pressure against the mirror cover
or mirror surface while opening it.
•Keep finger prints off the mirror surface. Leaving finger prints in
the mirror surface might cause an unwanted shadow and poor
picture quality.
To close the mirror cover:
1. Slowly close the mirror cover while holding both ends.
UNLOCK
MIRROR
LOCK
1
NOTE:
•Do not release your hold of the mirror cover until the mirror cover
is fully closed.
•Do not apply excessively strong pressure against the mirror cover
or mirror surface while closing it.
•Keep finger prints off the mirror surface. Leaving finger prints in
the mirror surface might cause an unwanted shadow and poor
picture quality.
2. Slide the mirror cover lock switch to the lock position.
UNLOCK
MIRROR
LOCK
2
NOTE:
•The projector cannot be turned on when the mirror cover is closed.
•Keep any items out of the light path or the mirror. Failure to do so
may cause objects to catch on fire in unexpected places.
•The projector has a sensor which detects an object in front of the
largest mirror or in the light path. If the sensor detects any object,
the projector will not turn on. If this happens while the projector is
turned on, the image is muted. In either case the STATUS indicator
lights in red.
•The projector has a temperature sensor which detects heat. If the
sensor detects excessive heat in the bottom of the mirror or in the
light path, the projector will not turn on. If this happens while the
projector is turned on, the projector will turn off (Standby mode).
In either case the STATUS indicator flashes in red.