13
Part Names and Functions of the Supplied Electronic Pen (WT615 only)
The WT615 comes with an electronic pen.
The electronic pen works as a USB mouse connected to the projector. See page 53 for connecting a USB mouse.
The electronic pen and the projector’s sensors can be used to convert your whiteboard into a virtual touchscreen which
allows you to operate your projector’s menu or use the ChalkBoard feature. See “ Using the Electronic Pen” on page 45.
Important
Before you use the electronic pen or when you have changed the position of the projector or the screen size, be sure
to use [Calibration] to calibrate the electronic pen and the screen.
1. Introduction
The buttons work as computer mouse buttons.
Pen tip................... Left click button
Button A................ Right-click button
Button B................ Button to turn on or off the ChalkBoard toolbar.
NOTE:
•Button A or B must be pressed and held for a minimum of 0.5 second.
• Pressing and holding the buttons A and B at the same time for a minimum of 0.5 second will change to “Pen Calibration”
mode. See also page 47.
Pen tip
Button A
Button B
Requirements for the Electronic Pen Function
•Screen size: 40” to 80”
•Projector orientation: “Desktop Front” and “Ceiling Front”
•[Screen Type]: “4:3”
•[Aspect Ratio]: “4:3”
•Digital Zoom: 100%
•[Cornerstone] and [Keystone]: Not performed
•Operating temperature: 59 to 95°F (15 to 35°C)
•[Resolution]: "Auto"
Battery Installation
123
Electronic Pen Precautions
•Handle the electronic pen carefully.
•If the electronic pen gets wet, wipe it dry immediately.
•Avoid excessive heat and humidity.
•If you will not be using the electronic pen for a long time, remove the battery.
•Dispose of a used battery according to your local regulations.
NOTE: Do not hold this part. Otherwise, the electronic pen
may not work properly.