6
by connecting to a mixing console's main inserts, or on an entire mix "in-line" between a mixing console's outputs
- Wiring Configuration
and a power amplifier. Defective wiring may degrade the performer of MP8 so, please, use good quality screened
audio cables only. Please follow the guide below to interface MP8 without experiencing any noise or signaloss.
Either the 1/4" TRS phone jack or the XLR connector can be wired in balanced and unbalanced modes, which
will be determined by the actual application status, please wire your system as the following wiring examples:
4.1 Mains Connection
4.2 Audio Connection
Please ensure that the MP8 is set to the correct supply voltage before plugging the power cord into the wall outlet,
use the same fuse as marked on the fuse holder at the AC power connection. The mains connection of the MP8
is made by using the enclosed mains cord and a standard IEC receptacle. It meets all of the tional safetyinterna
certification requirements.
The MP8 presents with balanced XLR & 1/4" TRS and combo connectors, and it can be interfaced by several
ways to support a variety of applications without any signal loss. The MP8 can be used on a single instrument
4: INSTALLATION AND CONNECTION
For XLR connector
XLR Type Unbalanced XLR Type alancedB
Pin3 (-)
Pin2 (+)
Pin1 ( )
(Linked to Pin1 manually, )
Pin1 ( )
Pin2 (+)
Pin3 (-)
For 1/4" Phone jack
TS Type Unbalanced TRS Type Balanced TRS Type Unbalanced
Sleeve
Tip
+
Tip
Ring
Sleeve
+
-
Tip
Ring
Sleeve
+
- XLR Connector Wiring For Phantom Power
PIN1 GND
PIN 2 +48v
PIN 3 +48v