8
Totighten the lock nut, press the shaft lock firmly so that the
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the wheel, follow theinstallation procedure in
reverse.
Installing or removingflex wheel
(optional accessory)
WARNING:
• Always use supplied guard when flex wheel is on tool.
Wheelcan shatter during use and guard helps to reduce
chances of personal injury.
Follow instructions for depressed center grinding wheel/
Multi-disc but also use plastic pad over wheel. See order of
assemblyon accessories page in this manual.
Installing or removing abrasive disc
(optional accessory)
NOTE:
• Use sander accessories specified in this manual. These
must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on the
rubber pad and screw the lock nut onto the spindle. To
tighten the lock nut, press the shaft lock firmly so that the
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.
OPERATION WARNING:
• It should never be necessary to force the tool. The
weight of the tool applies adequate pressure. Forcing
and excessive pressure could cause dangerous wheel
breakage.
• ALWAYSreplace wheel if tool is dropped while grinding.
1. Lock nut wrench
2. Shaft lock
1
2
001083
1. Lock nut
2. Flexwheel
3. Plastic pad
4. Inner flange
1
4
3
2
001095
1. Lock nut
2. Abrasivedisc
3. Rubber pad
1
3
2
001106