Novatel OM-AD-0020 Test Bed Receiver Subsystem

ii Test Bed Receiver Subsystem Addendum – Rev 1

Test Bed Receiver Subsystem

Addendum

Publication Number: OM-AD-0020

Revision Level: 1 00/4/11

This manual reflects Test Bed firmware revision levels 4.52s3 (GPS/GEO) and 6.48s16 (GPS/GLONASS).

Proprietary Notice

Information in this document is subject to change without notice and does not repr esent a commitment on the part of

NovAtel Inc. The software described in this document is furnis hed under a license agreement or non-disclosure

agreement. The software may be used or copied only in accordance with the terms of the agreement. It is against the law

to copy the software on any medium except as specifically allowed in the li cense or non-disclosure agreement.

No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical,

including photocopying and recording, for any purpose without the express written permission of a duly authorized

representative of NovAtel Inc.

The information contained within this manual is believed to be true a nd correct at the time of publication.

P-Code Delayed Correlation Technology, GPSAntenna, GPSCard, MEDLL, MET, MiLL ennium and Narrow

Correlator are trademarks of NovAtel Inc.

Belden is a registered trademark of Belden Inc.

© 2000 NovAtel Inc. All rights reserved

Unpublished rights reserved under International copyright laws.

Printed in Canada on recycled paper. Recyclable.

Contents

Main Test Bed Receiver Subsystem Addendum Proprietary Notice TABLE OF CONTENTS Page TABLES Page FOREWORD SCOPE PREREQUISITES 1 INTRODUCTION THE NOVATEL TEST BED RECEIVER 1 - Introduction Test Bed Receiver Subsystem Addendum Rev 1 9 OPERATIONAL OVERVIEW L1/L2-I L1/L2-II GEO Processing Single Frequency GPS GLONASS Dual Frequency GPS GEO Other Outputs & Inputs 2 INSTALLATION OF TEST BED RECEIVER MINIMUM CONFIGURATION INTERNAL AND EXTERNAL OSCILLATORS CONNECTING THE EXTERNAL FREQUENCY REFERENCE CONNECTING DATA COMMUNICATIONS EQUIPMENT DCD RXD TXD DTR GND DSR RTS CTS NC CONNECTING THE GPS ANTENNA CONNECTING THE EXTERNAL POWER INPUT USING THE 10 MHz OUTPUT SIGNAL Page 3 OPERATION PRE-START CHECK LIST SERIAL PORTS - DEFAULT SETTINGS START-UP INITIAL COMMUNICATIONS WITH THE TEST BED RECEIVER 4 UPDATE OR UPGRADE YOUR GPSCARD UPGRADING USING THE $AUTH COMMAND UPDATING USING THE LOADER UTILITY TRANSFERRING FIRMWARE FILES USING THE LOADER UTILITY A WAAS OVERVIEW B GLONASS OVERVIEW MILLENNIUM-GLONASS GPSCARD X GLONASS SYSTEM DESIGN The Space Segment The Control Segment The User Segment TIME GLONASS TIME VS. LOCAL RECEIVER TIME DATUM FUNCTIONAL OVERVIEW MILLENNIUM-GLONASS GPSCARD SYSTEM Reference Description Reference Description GPS/GLONASS ANTENNA RADIO FREQUENCY (RF) SECTION DIGITAL ELECTRONICS SECTION Page C COMMANDS CONFIG IONOMODEL WAASCORRECTION LOGS RCCA RECEIVER CONFIGURATION D GLONASS COMMANDS AND LOGS GLONASS-SPECIFIC COMMANDS DGLOTIMEOUT Syntax: Options: PZ90TOWGS84 Syntax: Options: Example: PZ90TOWGS84 DEFAULT UNIMPLEMENTED COMMANDS GLONASS-SPECIFIC LOGS CALA/B CALIBRATION INFORMATION CALA Page CALB Format: Message ID = 87 Message byte count = 32 + (16 * 32) GALA/B ALMANAC INFORMATION GALA GALB Format: Message ID = 78 Message byte count = 112 GCLA/B CLOCK INFORMATION GCLA Table 2 Time Status Example: $GCLA,994,149871.00,10787,10.62179349,167.82950123,1121, -3.0544738044739E-007,9,4,00000000*7B,[CR][LF]GCLB GCLB Format: Message ID = 88 Message byte count = 68 GEPA/B EPHEMERIS INFORMATION GEPA Example: $GEPA,991,496487.00,991,495913.00,10787,4,12,83,0,-2.102581933593754E+007 GEPB Format: Message ID = 77 Message byte count = 156 Page OTHER NOVATEL LOGS RCCA RECEIVER CONFIGURATION E TEST BED RECEIVER - TECHNICAL SPECIFICATIONS Page Appendices 50 Test Bed Receiver Subsystem Addendum Rev 1 Default Channel Assignments INDEX