POWER ON

Setup

Input Selection

Paper Selection

Picture Selection

Printing Modes

Printing

Tips

•The “PRINTING” lamp lights when printing is in progress.

•Continuously press the MENU/PRINT Cancel button to cancel printing. When print cancellation is accepted, the xD-Picture Card, PC Card and PRINTING access indicators flash. At this time, the message “Printing will Stop After this Paper” is displayed on the LCD panel, and printing stops after the current sheet of paper is printed out normally.

•If the printer runs out of paper or ink ribbon after the PRINT button has been

pressed, a message is displayed and printing is stopped. Install paper or ink ribbon and then press the PRINT button to resume printing.

•Since printing is performed by using one color each of Y (yellow), M (magenta) and C (cyan) and an overcoating, the printer head passes back and forth over the paper four times to print one color print.

Caution

•When tearing off postcard paper (P-A4P) or L size paper (P-A4L), first bend along the vertical scored lines and then tear off both ends. Next, bend along the remaining scored lines and tear off. The paper cannot be torn off cleanly unless folds are firmly made in the paper.

1Carefully bend along the vertical scored lines 2Tear the paper vertically. on the top and bottom.

3Carefully bend along the horizontal scored lines on the top and bottom.

4Tear the paper horizontally.

139