42

Observe the following when soldering wires onto the connector.
1. Place heat-shrinking tubes onto all wires far enough from the end so as
to not interfere with soldering.
2. Presolder all wires and connector terminals.
3. Solder all wires, inserting 4 mm of the exposed 5 mm of wire into the
connector terminal.
4. Move the heat-shrinking tubes onto the soldered area and shrink them
into place.
Assemble the connector hood as shown the following diagram. See the con-
nection diagrams above to confirm whether one end is or is not to be con-
nected to the shield wire.
Aluminum foil tape
Hood (FG) connected
to shield wire Hood (FG) not connected
to shield wire
5-2 Dimensions
Unit: mm
250
100*
Approx.
150**
Backplane
35
Soldering
1, 2, 3...
Hood Assembly
C500-LK009-V1

Dimensions Section 5-2