Connecting the Power/ Turning on the DVD Player

Before connecting

•The DV-L5X is shipped with the main power (POWER) switch in the on position (_ ON). When the power cord is plugged in for the first time, the DV-L5X will automatically enter the standby state (same condition after step 2 below).

•Make sure that all the connections on pages 13 and 14 are complete (the connection to a TV is required).

POWER STANDBY/ON

ON indicator STANDBY indicator

1

Connect the power cord to a wall

outlet.

2

Press POWER to switch on the main

power.

The DVD Player enters standby mode.

The STANDBY indicator lights up.

•The buttons on the remote controller do not operate if the POWER switch is set to OFF.

•To switch off the main power, press POWER again.

3

Press STANDBY/ON on the DVD

Player or ON on the remote

controller.

The DVD Player turns on.

The STANDBY indicator turns off and the

ON indicator lights up.

•To put the DVD Player in the standby mode, press STANDBY/ON on the DVD Player, or STANDBY on the remote controller. Be sure to set the volume to minimum before putting the DVD Player in the standby mode for the next use to avoid sudden loud sound reproduction.

•While in the STANDBY mode, the DVD Player can receive signals from the remote controller. However, if you press POWER on the DVD Player to switch off the main power, the remote controller cannot be used to turn on the DVD Player.

•Setting the STANDBY button to standby does not shut off the power completely.

■Setting the TV System (except for USA and Canadian models)

The default setting of this player is AUTO, and unless you notice that the picture is distorted when playing some discs, you should leave it set to AUTO.

If you experience picture distortion with some discs, set the TV system to match your country or region’s system. Doing this, however, may restrict the kinds of disc you can watch. The table below shows what kinds of disc are compatible with each setting (AUTO, PAL and NTSC).

Disc

 

 

 

 

Output format

 

 

 

 

 

 

 

 

 

Type

Format

 

Position of TV SYSTEM mode

 

 

 

NTSC

PAL

AUTO

 

 

 

 

 

 

 

 

DVD

NTSC

NTSC

MOD. PAL

NTSC

 

 

PAL

 

 

 

PAL

PAL

 

 

 

 

 

 

 

 

 

 

 

 

 

Video CD

NTSC

NTSC

MOD. PAL

NTSC

 

 

 

 

 

 

 

 

 

 

PAL

NTSC

PAL

PAL

 

 

 

 

 

 

 

 

CD, No disc

 

NTSC

PAL

NTSC or PAL

1Switch the player into standby.

2Hold down ¢ then press STANDBY/ON until the display indicates the new setting to switch the TV system.

The TV system changes as follows:

AUTO = NTSC NTSC = PAL PAL = AUTO

Note that you have to switch the player into standby before each change.

About MOD. (Modulation) PAL

•SHRINK

Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch vertical amplitude, resulting in a display without vertical shrinkage.

•If your PAL TV does not have a V-Hold control, you may not be able to view NTSC disc because the picture may roll. If the TV has a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands at the top and bottom of the screen. This is not a malfunction; it is caused by the NTSC = PAL conversion.

You can connect AC power cord of other components (total capacity: maximum 120 W) to the AC outlet on the rear panel of this player.

15