Connecting the antenna cable to the 75/300 ohm antenna adapter (Non- U.S., Canadian and European models)
Connecting the 300 ohm ribbon wire:
Loosen the screws and wrap the wire around these screws. Then tighten the screws with a screwdriver.
OutdoorIndoor
antennaantenna
300 ohms ribbon wire
Connecting the coaxial cable:
1.With your fingernail or a small screw- driver, press the stoppers outward and remove the cover.
2.Remove the transformer wire A from slit B and insert it into slit C.
3.Prepare the coaxial cable as shown in the diagram.
Connect the 75/300 ohm antenna adapter to the coaxial cable.
1 Insert the end of the cable.
2 Clamp it in place with pliers.
4.
|
|
|
|
| Slit B |
|
|
|
|
| Wire A |
Slit C |
|
| |||
|
| ✦ |
|
|
|
✦ | ✦ | ✦ |
|
| |
✦✦ | ✦ ✦ | ✦ |
|
| |
| ✦ ✦ |
|
|
| |
|
| 6 | 3 | 6 | 1 |
| mm mm mm | ||||
|
| 15mm |
|
2
Directional Iinkage
Directional Iinkage type splitter
To | To TV (or VCR) |
Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.
19