Onkyo TX-8222, TX-8522 Naming Preset Channels, Entering a Name, Correcting a Character

TX-85228222_En.book 30 ページ ２００６年５月４日 木曜日 午前１１時５１分

Naming Preset Channels

While receiving a preset FM or AM station, a maximum of 8 characters consisting of letters, numbers and some symbols can be stored, for example to represent the station name.

You cannot assign a name to the RDS station (for European model) and the SAT RADIO channel (for North American model).

Characters which can be entered: A B C D E F G H I J K L M N O P Q R S T U V W X Y Z 1 2 3 4 5 6 7 8 9 0 – * /

Note: indicates a space.

Number buttons

TUNING DOWN/UP CHARACTER

Entering a Name

As an example, assume an FM station with a frequency of 89.50 MHz has been stored in preset number 2 and will be given the name “ONKYO.”

1	Select the desired preset
	channel.
	(Refer to “Selecting Presets” on
	page 27.)
2 TXNorth-8522	Press the [CHARACTER] button
American	on the front panel.
	The frequency in the display goes off
	and the cursor ( _ ) flashes.
TX-8222
Other than
European

5	Press the [CHARACTER] button
	to store the entered characters.

If a button is not pressed within 16 seconds, the operation will end automatically.

Note:

Press the [DISPLAY] button when you wish to check the frequency while you are entering the characters.

Correcting a Character

1	Select the desired station.
	(Refer to “Selecting Presets” on page 27.)
2	Press the [CHARACTER] button.
	The first character and the cursor flash
	alternately.
3	Press the TUNING [ DOWN] or [UP	]
	button to move the cursor below the
	character that you wish to change.
	The cursor moves to the right when the [UP	]

3

TX-8222

Other than

European model

Continue pressing the [5MNO] button until “O” is displayed.

With each press of the button, the character that appears in the display changes one at a time in the following sequence: 5 → M → N → O → 5...

If a button is not pressed within one second, the cursor automatically moves to the next position.

button is pressed and moves to the left when the

[ DOWN] button is pressed.

Clearing all characters:

Press [DIRECT TUNING] button.

4	Enter the desired character.
	The previous character is replaced with a new
5	character.
	Press the [CHARACTER] button.

4	Continue pressing number
	buttons to enter the desired
	characters.
	To enter N, press the [5MNO] button.
	To enter K, press the [4JKL] button.
	To enter Y, press the [9YZ-] button.

30