Listening to the Radio—Continued
■Tuning into Stations by Frequency
You can tune into AM and FM stations directly by entering the appropriate frequency.
1 | Receiver | Press the [DIRECT TUNING] | ||
button. | ||||
|
| |||
|
|
|
| |
|
|
|
| |
|
|
|
|
Remote | (Actual display depends on country.) | |
controller | ||
|
4 |
| Press the [MEMORY] button |
| again to store the station or | |
| Receiver | |
| channel. | |
|
|
The station or channel is stored and the preset number stops flashing.
Repeat this procedure for all of your favorite AM/FM radio stations.
■ Selecting Presets
2
Receiver
Remote
controller
Within 8 seconds, use the number buttons to enter the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5.
1 | To select a preset, use the | |
number buttons on the receiver, | ||
Receiver | ||
| or the remote controller’s | |
| PRESET [ ]/[ ] buttons. | |
| + − | |
Remote |
| |
controller |
|
Presetting AM/FM Stations
Number buttons
PRESET
/
MEMORY | TUNING MODE |
You can store a combination of up to 40 of your favorite AM/FM radio stations as presets.
1 | Tune into the AM/FM station that | |
you want to store as a preset. | ||
| ||
|
| |
2 | Press the [MEMORY] button. | |
|
Receiver The MEMORY indicator appears and the preset number flashes.
3 | While the MEMORY indicator is | |
displayed (about 8 seconds), use | ||
Receiver | ||
| the number buttons on the | |
| receiver to select a preset from 1 | |
| through 40. |
■Deleting Presets
1Select the preset that you want to delete.
See the previous section.
2While holding down the
Receiver | [MEMORY] button, press the |
| [TUNING MODE] button. |
The preset is deleted and its number disappears from the display.
The North American model changes FM frequency in
0.2MHz steps, 10 kHz steps for AM. For other models the frequency changes in 0.05 MHz steps for FM and 9 kHz (or 10 kHz) steps for AM.
When tuned into a station, the TUNED indicator appears. When tuned into a stereo FM station, the FM STEREO indicator also appears.
TUNED AUTO
FM STEREO
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual Tuning mode and listen to the station in mono.
29