Connecting antennas
To the use the tuner of
•Adjustment and placement of the FM and AM antennas for better reception must be done while listening to a station broadcast.
•If better reception cannot be obtained, then placement of an outside antenna is recommended.
2.Insert the bottom edge of the outer frame into the
groove on the stand.
Insert into the groove.
Connecting the FM indoor antenna
North American models:
1.Strip away the insulation from the end of the cord.
FM indoor antenna
2. Fully insert the stripped end of the cord.
SUB
ANTENNAWOOFER
PRE OUT
R L
OUT
AM
TAPE
3. Extend the antenna cord.
Connecting the AM loop antenna
1. Press down the lever.
2. Insert the end of the cable into the hole.
FM 75
Except for North American models:
MONI-
INTOR OUT
DVDIN
3. Release the lever.
The lever will return to the original position.
Fully insert the end of the cord.
SUB
ANTENNAWOOFER
PRE OUT
R L
OUT
AM
TAPE
AM loop antenna
FM 75
MONI-
INTOR OUT
DVDIN
SUB
ANTENNAWOOFER PRE OUT
R L
OUT
AM
TAPE
MONI-
INTOR
OUT
The FM indoor antenna is for indoor use only. During use, extend the antenna and move it in various directions until the clearest signal is received. Fix it with push pins or similar implements in the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.
Assembling the AM loop antenna
1. Rotate the outer frame of the antenna.
FM 75
DVDIN
Either of the split ends of the AM antenna can be connected to either terminal. Unlike speaker cabling, there is no polarity for AM broadcast signals.
The AM loop antenna is for indoor use only. Set it in the direction and position where you receive signals clearly. Put it as far away as possible from the
When reception is not satisfactory with the attached AM loop antenna alone, connection of an outdoor antenna is recommended.
18