Connections (TX-SR600/600E)

Connecting a DVD Player with 2-Channel (L/R) Audio Output

ANTENNA

COMPONENT VIDEO

INPUT 2 INPUT 1 OUTPUT

 

FM

 

AM

 

 

 

 

 

Y

 

75

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

PB

 

 

 

 

 

 

 

 

 

REMOTE

 

 

 

 

 

 

 

 

 

PR CONTROL

DIGITAL INPUT

DIGITAL

DIGITAL

VIDEO 3

VIDEO 2

VIDEO 1

DVD

MONITOR

 

 

OUTPUT

INPUT

IN

IN

OUT

IN

IN

OUT

 

OPTICAL

OPTICAL

COAXIAL

 

 

 

 

 

VIDEO

2

1

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

S VIDEO

 

CD

TAPE

 

IN

OUT

 

 

SURR CENTER

 

IN

OUT

IN

IN

IN

FRONT

 

L

 

 

L

 

 

 

 

L

 

 

 

 

 

 

 

 

SUBWOOFER

PRE OUT

R

R

 

R

 

 

 

 

VIDEO 3 VIDEO 2

VIDEO 1

SUB

 

WOOFER

DVD

: Signal flow

3. Connecting a DVD player (DVD)

Using an RCA video cable, connect the video output jack (composite) of the DVD player to the DVD VIDEO IN jack of the TX-SR600/ 600E. Or if the DVD player has an S video output jack, connect it to the DVD S VIDEO IN jack with an S video cable. Or if the device has component video outputs, connect them to the COMPONENT VIDEO INPUT 1 or 2 jacks on the TX-SR600/600E.

With the initial settings of the TX-SR600/600E, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jacks.

If you connect the DVD player to the COMPONENT VIDEO INPUT 2 jacks, this must be changed at “Input Setup” → “Component Video” (see page 54).

Using an RCA audio connection cable, connect the audio output jacks of the DVD player to the DVD FRONT L/R jacks of the TX- SR600/600E. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a 5.1-channel output, connect the DVD FRONT L/ R, SURR L/R, CENTER, and SUBWOOFER (5.1-channel input) jacks of the TX-SR600/600E to the 5.1-channel output jacks of the DVD player. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL INPUT COAXIAL jack or the DIGITAL INPUT OPTICAL jack of the TX-SR600/600E depending on the type of connector on the DVD player.

With the initial settings of the TX-SR600/600E, the DVD input source is set for digital input at the COAXIAL jack (COAX).

If the digital connection is made at a different jack, this must be changed at “Input Setup” → “Digital Input” (see page 53).

Note:

If the DVD player has both 5.1-channel audio outputs and 2-channel audio outputs, and you want to connect the DVD player only using the FRONT L/R jacks on the TX-SR600/600E, use the 2-channel audio output jacks on the DVD player.

Y

PB

Component video output

PR

Video ouput

S video output

3. DVD player (DVD)

L (white)

Analog audio output R (red)

Digital audio output (coaxial)

26