14
Installation
Warning Indicator
▀■ When the “LAMP” indicator lights solid red, the projector
will automatically shut itself down. Please contact your local
reseller or service centre. See page 47.
▀■ When the “TEMP” indicator flashes red, it indicates the pro-
jector has overheated. The projector will automatically shut
itself down.
Under normal conditions, the projector can be switched on
again after it has cooled down. If the problem persists, you
should contact your local dealer or our service center. See
page 47.
▀■ When the “LAMP” indicator flashes red, it indicates the fan
has failed. Please contact your local dealer or our service
centre. See page 47.
Powering Off the Projector
1. Press the “ ” button to turn off the projector lamp, you will
see a message displayed on the projector’s screen.
Press the “ ” button again to confirm, otherwise the mes-
sage will disappear after 5 seconds.
2. The cooling fans continue to operate for about 60 seconds for
cooling cycle and the Power LED will flash blue. When the
lights solid red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and has
entered standby mode. Once in standby mode, simply press
“ ” button to restart the projector.
3. Disconnect the power cord from the electrical outlet and the
projector.
4. Do not turn on the projector immediately following a power
off procedure.