EN
4. Relax and put the tip of your thumb or index finger on the pulse sensor.
5.Wait for about 10 seconds until the word FINISH appears on the LCD panel.
6.Repeat
calibration fails.
It’s highly recommended to calibrate your individual stress index baseline once a month or whenever you want to refer to your parameter in different situations.
To measure pulse and stress level:
1.Keep calm before and during measuring.
2.Press 
.
3.Put the tip of your thumb or index finger on the IR sensor.
4.Wait for about 10
seconds until pulse rate is shown (e.g. 100).
10
5. The LCD will display your stress level as follows:
ICON | BAR COLOR | MEANING |
| Green | Relaxed |
| Yellow | Normal |
| Red | Not relaxed |
Retry if failed (if no reading is showing within 1 minute the pedometer will escape from pulse mode). You then press pulse rate button 
again.
TIPS
•Cold fingertips and cold air can affect the measurement. You may need to warm your hands before you start.
•The sensor is sensitive to light sources. Cover the entire sensor area with your fingertip to block all light.
•Gently touch the pulse sensor; do not press hard.
•Keep still and calm during measurement. Moving about can affect the reading.
•Wait the proper amount of time: Measurements can take
What is your stress index?
The stress index measurement is based on heart rate variability, which indicates your involuntary nervous system’s status.
PE82X_M_EN_V2.p65 | 10 | 2005.7.19, 12:17 PM |
