Outlaw Audio 970 owner manual System Configuration Settings, Available choices are

Owner’s Manual

System Setup

System Configuration Settings

This final sub-menu lets you adjust some convenience and comfort parameters that enable you to enjoy the Model 970 even more by custom tailoring key set- tings. Note that some of these settings may require a bit of experience with the Model 970 in its factory default mode before you decide which to change, and to what degree the changes should be made. If you are in a rush to get your new Model 970 into action, there is no problem in leaving the factory settings in place and returning to this menu later to make the desired changes.

1.Press the MENU button on the front panel or the remote to display the Main Menu.

The Main Menu appears on-screen:

MAIN MENU

> INPUT	CONFIG
SPEAKER	SIZE
SPEAKER	X-OVER
SURROUND	CONFIG
CHANNEL	CALIBRATION
DELAY	ADJUST
SYSTEM	CONFIG
EXIT

2.Move the cursor to system config by using the and buttons on the front panel or remote.

3.With the cursor pointing to system config, press SET on the front panel or the remote.

The Channel Calibration sub-menu appears:

system config

>osd time out :3osec display time out :on volume default :last default vol :-25db

sleep :OFF

return to main menu

OSD (On-screen display) Time Out

This setting determines the length of time that the on-screen messages (vol- ume change, input selection, surround mode, etc.) appear on the on-screen display.

To adjust the OSD time out:

1.From the system Config menu, press or to move the cursor to osd time out.

2.Press the and buttons on the front panel or remote to select the desired setting.

The available choices are:

5sec10sec15sec20sec25sec30sec

Display Time Out:

This setting determines if the on screen messages and setup menus time out (disappear from the screen) after the length of time selected in the OSD TIME OUT line, as shown above. In most cases you will want to use the ON setting. However, when making adjustments during the setup process, you may want to leave the menus on until you intentionally turn them off.

To set display time out:

1.From the system Config menu, press or to move the cursor to display time out.

2.Press the and buttons on the front panel or remote to toggle between ON and OFF.

Selecting ON (default) will cause on-screen messages to disappear after the time period set in OSD Time Out.

Selecting OFF will make on-screen messages remain visible until the Menu button on the remote or front panel is pressed.

Volume Default

This setting determines the volume level when the Model 970 is turned on.

To set the Volume Default:

1.From the system Config menu, press or to move the cursor to volume default.

2.Press the and buttons on the front panel or remote to toggle between last and ON.

Choose LAST (default) to have the Model 970 always turn on at the same volume level in place when it was turned off.

Choose ON to always have the Model 970 play at the level specified in Default Volume each time you turn it on.

Default Volume

If you selected ON in the VOLUME DEFAULT menu above, your Model 970 will always turn on at the same volume. Use the Default Volume setting to enter that volume level.

To set the Default Volume level:

1.From the system Config menu, press or to move the cursor to default volume.

2.Press the and buttons on the front panel or remote to select the desired setting.

You can adjust the level from -70 to +10dB.

Keep in mind that a -70dB setting will be below your threshold of hearing and +10dB may well make your ears bleed.

We suggest something in the range of -30 dB. That way, you’ll be sure to know that your system’s on and working.

34

Outlaw Audio