Adjusting POS. /SIZE
●AUTO SETUP
This setting is enabled under the following conditions:
•When
•When the signal is not PC format, this setting is enabled only if “OVER SCAN” (see page 30) is “OFF” or “1:1 PIXEL MODE” (see page 30) is “ON”, and
This setting will be invalid and will not work under the following conditions:
•Aspect is set to “JUST”
•“UNDER SCAN” is set to “ON”
Using Remote Control
When on the remote control is pressed, “AUTO SETUP” will be executed.
When AUTO SETUP does not work, “INVALID” is displayed.
Auto mode
When the “Auto Setup“ is set to “Auto” in the OPTIONS menu (see page 56), automatic position adjustment starts:
•When the display power is turned ON.
•When the input signal is switched.
Notes:
•If the dot clock frequency is 162 MHz or higher, DOT CLOCK and CLOCK PHASE cannot be made.
•When digital RGB signal input, DOT CLOCK and CLOCK PHASE cannot be made.
•AUTO SETUP may not work when a cropped or dark image is input. In such case, switch to a bright image with borders and other objects are clearly shown, and then try auto setup again.
•Depending on the signal, out of alignment may occur after AUTO SETUP. Carry out fine tuning for the position/size as required.
•If AUTO SETUP cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz, 1280×768@60Hz, and 1366×768@60Hz),
•AUTO SETUP does not work well when a signal such as additional information is superimposed out of valid image period or intervals between synchronizing and image signals are short, or for image signal with
•If AUTO SETUP cannot adjust correctly, select “NORMALIZE” once and press OK button then adjust POS. /SIZE manually.
● | Adjust the horizontal position. | ||||
|
|
|
|
|
|
● | Adjust the horizontal size. | ||||
|
|
|
|
|
|
● | Adjust the vertical position. | ||
|
|
|
|
|
|
|
|
|
|
|
|
● | Adjust the vertical size. | |
|
|
|
|
|
|
|
|
|
|
|
|
● DOT CLOCK (During Component, RGB and PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens, adjust so that any such noise is minimized.
●CLOCK PHASE (During Component, RGB and PC input signal) Eliminate the flickering and distortion.
29