Using Network Function
PJLink™ ProtocolThe network function of the unit conforms with PJLink™ class 1 and you can operate the following actions from your computer using PJLink™ protocol.
•Display setup
•Display status query
Supported commands
Commands to control the unit with PJLink™ protocol are shown in the table below.
Command | Control | Remark | |
POWR | Power control | Parameter |
|
0 = Standby 1 = Power “On” |
| ||
|
|
| |
POWR? | Power status query | Parameter |
|
0 = Standby 1 = Power “On” |
| ||
|
|
| |
INPT | Input switch | Parameter |
|
INPT? | Input switch query | See the parameter for command INST? |
|
AVMT | Shutter control | Parameter |
|
|
| 10 = Picture On (picture mute deactivated), 11 = Picture Off (picture on mute) | |
|
| 20 = Audio On (audio mute deactivated), 21 = Audio Off (audio on mute) | |
|
| 30 = Shutter mode Off (picture and audio mute deactivated) | |
|
| 31 = Shutter mode On (picture and audio on mute) | |
AVMT? | Shutter control query | Parameter |
|
|
| 11 = Picture Off (picture on mute) |
|
|
| 21 = Audio Off (audio on mute) |
|
|
| 30 = Shutter mode Off (picture and audio mute deactivated) | |
|
| 31 = Shutter mode On (picture and audio on mute) | |
ERST? | Error status query | Parameter |
|
|
| First byte: Means fan error. 0 or 2. |
|
|
| Second byte: 0 |
|
|
| Third byte: 0 |
|
|
| Fourth byte: 0 |
|
|
| Fifth byte: 0 |
|
|
| Sixth byte: Means other error. 0 or 2. |
|
|
| Meaning of the 0 – 2 settings: |
|
|
| 0 = Error is not detected, 2 = Error |
|
LAMP? | Lamp status query | Not supported |
|
INST? | Input switch list query | Parameter |
|
|
| Numbers 11 to 13 are depending on the slot installation condition | |
|
| 11: PC IN input (PC) | When a dual input terminal board is |
|
| When a single input terminal board | |
|
| is attached | attached |
|
| 11: SLOT input (SLOT INPUT) | 11: SLOT input (SLOT INPUT A) |
|
| 12: PC IN input (PC) | 12: SLOT input (SLOT INPUT B) |
|
|
| 13: PC IN input (PC) |
|
| 21: COMPONENT/RGB IN input |
|
|
| (COMPONENT) |
|
|
| 31: HDMI 1 input (HDMI1) | 32: HDMI 2 input (HDMI2) |
|
| 33: HDMI 3 input (HDMI3) | 34: HDMI 4 input (HDMI4) |
NAME? | Projector name query | Returns empty character (no name information) | |
INF1? | Manufacturer name query | Returns “Panasonic” |
|
INF2? | Model name query | Returns | |
INFO? | Other information query | Returns version number |
|
CLSS? | Class information query | Returns “1” |
|
|
|
|
|
Set “Panasonic” for the PJLink™ password.
• PJLink™ is a pending trademark in Japan, the United States, and other countries or areas.
59