16
Tuning the TV to your unit (continued)
Preparations
≥Switch [VCR/TV/DVD] to “VCR”.
ªTo Restart Plug in Auto Tuning
Make sure there is no video cassette and disc loaded in the unit.
1) Keep both [CH] I and J on this unit pressed simultaneously
for 3 seconds or more while the unit is powered on.
≥The channel displayed on the unit’s display disappears for a
moment then changes to 2.
2) Disconnect the AC power cord and then reconnect it.
3) Turn on this unit.
4) Press [VCR/TV] to select the VCR mode.
≥Plug in Auto Tuning restarts.
If Auto Tuning stops halfway by turning the unit off or a power
failure:
1) Disconnect the AC power cord and then reconnect it.
2) Turn on this unit.
≥Plug in Auto Tuning restarts.
ªTo Change the RF Output Channel
In some rare cases after tuning the TV to your unit, interference
may be visible on the picture. To get rid of this interference, you
can manually adjust the RF output channel a few channels up and
down from the current setting. The procedure is described below.
1) Hold down [MENU] for 5 seconds or more.
≥The unit’s display changes as shown below and the VCR
picture on the TV displays this pattern.
2) Enter the desired channel number (3 or 4) by [CH]IJ.
3()4
3) Press [MENU] to finish the setting mode.
4) Retune your TV to the new RF channel for this unit.
Note:
≥Even if the RF output channel has been changed, it is not
necessary to perform Auto Tuning.
VCR/DVD/TV
VCR/DVD
REC CHECK
REC
CH
VOLUME
TV TV
VCR DVD
123
789
0
100
456
SLOW/SEARCH
NAVI
TOP MENU
MENU
RETURN
PROG/CHECK
QUICK REPLAY
DISPLAY
JET REW
TIMER
ENTER
PLAY
LIST
INDEX/SKIP
OUTPUT
TRACKING/V-LOCK
AV
DIRECT
NAVIGATOR
CANCEL/RESET
MUSIC w/ PICTURE
SEARCH PICTURE SPEED
AUDIO
POSITION MEMORY
VCR/TV
SET UPA-B REPEATREPEAT
PLAY MODE
A.SRD CINEMA
SUBTITLE
ANGLE
CH
VCR
VCR/TV
CH
MENU
VCR/
DVD
TIMER REC
TAPE
REFRESH
AV2 IN
REC/OTR
CH
TIMER
CHECK
PICTURE
MODE
EJECT
VCR
STOP PLAY
JET REW
VIDEO
AUDIO
LR
POWER /I
Disappears 2
Display Symbol
Panasonic VCR
END: MENU
On Screen Display