54
Error
Messages
Before requesting service, check the following points once again.
On Screen Display
ªVCR
ªDVD
Self-diagnostic Indications
This unit has a self-diagnosis and display function. If this unit detects trouble during installation or during use, the following indications
automatically appear in the unit’s display. Indications are in the form of a single English letter plus two numbers, such as [H01].
ªVCR
ªDVD
PLEASE PUT IN A VIDEO
CASSETTE. ≥[REC¥] (¥REC/OTR) or [TIMER ] ( TIMER REC) has been pressed without a video
cassette inserted.
Insert a video cassette with an intact erasure prevention tab. 20, 22
PLEASE STOP THE
TAPE.
≥CHANNEL SET has been selected during playback. Stop the tape. 29
PLEASE SET THE
CLOCK. ≥[TIMER ] ( TIMER REC) or [PROG/CHECK] has been pressed when the clock is not set.
Set the clock. 28
PLEASE USE A
CASSETTE WITH TAB. ≥[REC¥] (¥REC/OTR) or [TIMER ] ( TIMER REC) has been pressed without a video
cassette with an intact erasure prevention tab.
Use a video cassette with an intact erasure prevention tab. 5
NO TIMER RECORDING
HAS BEEN SET. ≥[TIMER ] ( TIMER REC) has been pressed with no timer programs.
Set timer recording. 22
Cannot display group xx,
picture xx
≥You are trying to display incompatible pictures. —
The progressive out is set
to “Disable”
≥Go to “Video” in the SET UP menus, and select “Enable” in “Progressive Out (Component)”. 49
H∑∑, F∑∑
(∑∑ stands for a number.) ≥An error has occurred. The number following “H” or “F” depends on the status of the unit.
Reset procedure:
Press [POWERÍ/I] to switch the unit to the standby mode and then back to ON. Alternatively,
press [POWERÍ/I] to switch the unit to the standby mode, disconnect the AC power supply
cord, and then reconnect it.
≥If the service numbers fail to clear, note the service number and contact a qualified service
person.
—
—
U11 ≥Disc is dirty. Wipe it clean. 6
H∑∑, F∑∑
(∑∑ stands for a number.) ≥An error has occurred. The number following “H” or “F” depends on the status of the unit.
Reset procedure:
Press [POWERÍ/I] to switch the unit to the standby mode and then back to ON. Alternatively,
press [POWERÍ/I] to switch the unit to the standby mode, disconnect the AC power supply
cord, and then reconnect it.
≥If the service numbers fail to clear, note the service number and contact a qualified service
person.
—
No DISC ≥You haven’t inserted a disc; insert one.
≥You haven’t inserted the disc correctly; insert it correctly. —
32
No PLAY ≥You inserted a disc the unit cannot play.
≥You inserted a blank DVD-RAM.
≥A disc whose playback is restricted in the SET UP menus, “Disc”l”Ratings”, is inserted.
Change the “Ratings” setting.
6
—
49
ERROR ≥Incorrect operation performed. Read the instructions and try again. —