Controls and Their Functions

Audio Function Section (1)

s

r

rAUDIO LEVEL CH1 (audio channel 1 recording level) control

When the AUDIO SELECT CH1/CH2 switch u is set to MAN, the recording level of audio channel 1 can be adjusted by this control in addition to the AUDIO LEVEL CH1 control t on the side panel.

sMIC IN (microphone input) jack (XLR, 3-pin)

Connect an optional microphone to this jack. The power for the microphone is supplied from this jack.

tAUDIO LEVEL CH1/CH2 (audio channel 1/2 recording level) controls

When the AUDIO SELECT CH1/CH2 switch u is set to MAN, the audio level of audio chan- nels 1 and 2 can be adjusted using these controls.

However, the audio CH1 level can also be adjusted using the AUDIO LEVEL CH1 control r on the front panel.

uAUDIO SELECT CH1/CH2 switch (audio channel 1/2 auto/manual level adjustment se- lector) switch

This selects the method used to adjust the audio levels of audio channels 1 and 2. AUTO: For adjusting the levels automatically.

MAN: For adjusting the levels manually.

vAUDIO IN (audio input selector) switch

This selects the input signals to be recorded on audio channels 1 and 2.

FRONT [MIC]: The microphone input signals connected to the MIC IN jack s are recorded.

REAR [MIC]: The microphone input signals connected to the AUDIO IN CH1/CH2 connectors y are recorded.

REAR [LINE]: The line input signals connected to the AUDIO IN CH1/CH2 connectors y are recorded.

wREAR MIC POWER switch

ON: The phantom power is supplied to the rear microphone.

OFF: The phantom power is not supplied to the rear microphone.

xCUE switch

CH1: The audio CH1 signals are recorded on the cue track.

1/2: The signals of audio CH1 and CH2 are mixed together and recorded on the cue track.

CH2: The audio CH2 signals are recorded on the cue track.

yAUDIO IN CH1/CH2 (audio input channel 1/2) connectors (XLR, 3P) An audio component or microphone is connected here.

zAUDIO OUT connector (XLR, 3P)

This is connected to an audio component. The audio channels are coupled to the MONITOR SELECT switch • and switched in tandem.

{DC OUT (DC power output) connector

This is the DC 12 V output connector. A current of approximately 100 mA can be taken out.

– 12 –