GN | Preparation |
|
| |
E |
|
|
| |
L |
|
|
| |
I |
|
|
| |
S | Remote Control Unit | Subwoofer | ||
H | ||||
|
|
| ||
| Back side | Lithium battery | ||
| (included) | Preparation: | ||
|
| |||
|
|
| ||
|
|
| ≥ Connect the subwoofer (option). (page 56) | |
|
|
| Subwoofer level setting: | |
|
|
| ≥ You can change the subwoofer level. (page 34) | |
Position B | Subwoofer low pass filter setting: | |
3 | ≥ You can select the upper limit frequency of the | |
sound from subwoofer. (page 34) | ||
|
Battery holder 
1
Position A
Battery Installation
1Remove the battery holder.Pull the holder out at position B while pushing position A as indicated.
2Install the battery on the battery holder.3Insert the battery holder back into its original position.Battery Notes
≥Battery type: Panasonic lithium battery (CR2025) (included)
≥Battery life: Approximately 6 months under normal use (at room temperature)
Caution:≥Improper use of the battery may cause overheating, an explosion or ignition, resulting in injury or a fire.
≥Remove and dispose of an old battery immediately.
≥Do not disassemble or short the battery. Do not throw a battery into a fire.
≥Keep the battery away from children to avoid the risk of accidents.
≥Follow local regulations when disposing of the battery.
10Clock Setting | G |
| E |
| N |
| L |
| |
| I |
| The | S |
| H |
≥Turn your car’s ignition key to the ACC or ON position.
≥Press [SOURCE] (PWR).≥When the power is switched on for the first time, a demonstration appears on the display.
Press [DISP] (display) to change to regular mode.
1Press [DISP] (display).
Clock display
2Press and hold [DISP] (display) again for more than 2 seconds.
Hours blink
3Press [%] or [$].
Hours set
4Press [DISP] (display).
Minutes blink
5Press [%] or [$].
Minutes set
6Press [DISP] (display). 
Complete
Note:
≥“ADJUST” is displayed before adjusting the clock.
≥Press and hold [%] or [$] to change numbers rapidly.
Display Change
Press [DISP] (display).
When the power is off:
Clock display
Display off