CS-TE9DKE CU-TE9DKE / CS-TE12DKE CU-TE12DKE

13.4.1.4. Removal of Control Board Box

1.Remove the Front Panel according to the item 15.5.1.1.

2.Remove the Front Grille according to the item 15.5.1.2.

3.Remove the Control Board according to the item 15.5.1.3.

Note for Disassembly:

The Control Board Box can be removed without pulling out the Board. (Disconnect a variety of connectors and the Receiver & Display Unit first.)

4.Remove a fixing screw for interconnecting cables and a screw for earth wire.

5.Remove the screws (three) for Terminal Board and release the hook (one).

13.4.1.5.Removal of Fan Motor and Cross-Flow Fan

1.Remove the Front Panel according to the item 13.5.1.1.

2.Remove the Front Grille according to the item 13.5.1.2.

3.Remove the Control Board Box according to the item 13.5.1.4.

4.Remove the Drain Hose and Discharge Grille.

Note for Disassembly:

Be careful of Drain Hose that will be hard to pulled out.

5.Unscrew the Screws (two) on the left side of the Heat Exchanger.

Fig. 14

6. Loosen the Screw (one) between the Cross-Flow Fan and Fan Motor.

Fig. 12

6. Pull out the Control Board Box from the main unit.

Fig. 15

7. Pull out the Cross-Flow Fan by holding up the left side of the Heat Exchanger.

Fig. 13

Fig. 16

68