Parts supplied with the remote controller

See Table 1.

Remote controller installation guidelines

Mount the remote controller 3.3 to 4.9 ft. (1 to 1.5
meters) off the floor where it can sense the average
temperature of the room.
Do not mount the remote controller in a place
exposed to direct sunlight or where it is exposed to
outside air such as near a window.
Do not mount the remote controller behind a curtain or
other object so that it is separated from the air circula-
tion of the room.
Mount the remote controller inside the room being air
conditioned.
Installation location
Room temperature sensors are separately incorporated in both the indoor unit and the remote controller. Either sensor can
be used to sense the room temperature. The indoor unit sensor is usually used.
If you wish the remote controller to sense the room temperature, press the SENSOR button with a ballpoint pen or tool with
a small tip. (Refer to Fig. 9 on page 4 to locate the SENSOR button.)

How to install the remote controller

The remote controller is set to “Cool/Dry/Heat model” at
the time of shipment from the factory. If the purchased air
conditioner is a COOL/DRY model, follow the instructions
on the label and change the switch on the reverse side of
the remote controller unit to “Cool/Dry model”. (Fig. 1)
The remote controller is also set to “Single” at the time of
shipment from the factory. For multiple use, set the
switch on the reverse side of the remote controller unit to
“Multi”. (Fig. 1)
After all work is completed, if any switches have been
changed, then be sure to press the ACL (Reset) button.
(Refer to Fig. 9 on page 4 to locate the ACL (Reset) but-
ton.)
IMPORTANT
Switching the room temperature sensor
yt'Qyt'Q
1
Parts
Wired
remote
controller
Machine
screws
Tapping
screws
2
2
2
Spacers
1
Parts
1
1
Instruction
manual
erugiFerugiF
Installation
Instructions
Wire
harness
5/32 15/16"
5/32 15/16"
(4 25mm)
(4 25mm)
26.2 ft. (8m)
Table 1
In order to install this wired remote controller onto a wall-mounted model, the connection kit
(CZ-RC515U or CZ-RC515UA), which must be purchased separately, is required.
Once the wired remote controller is connected, the wireless remote controller cannot be used.
IMPORTANT
Fig. 1

Wired Remote Controller

85264190592000 2011

INSTALLATION INSTRUCTIONS

CV6233187884