Panasonic CY-VHD9500U Remote Control Unit Preparation, Close the Display Unit

E	Monitor Position Adjustment
GN
L
I
S
		Open the Display Unit	Display Unit Lateral Angle
H
7		(PUSH OPEN)	Adjustment

Maximum 120e

30e

30e

1Push the display release button (PUSH OPEN)	You can swivel it to the left and right, 30˚ each way.
until the display is unlocked.	Hold the display unit by the non-slip part in the
(Press the button with one hand while holding
	upper half of it and adjust its lateral angle.
the display with the other.)
2Open the display unit by both hands until a
comfortable viewing angle is reached.

Close the Display Unit

Move the display unit by both hands until the display release button is locked.

Note:

≥Always use both hands to open or close the display unit.

≥Always check that the display release button is locked after closing the display unit.

≥If the display unit cannot be locked, be sure to consult your dealer and remedy the situation.

50CY-VHD9500U

Remote Control Unit Preparation		E
		G
		N
		L
		I
Battery Installation	Battery Notes	S
		H
1 Remove the battery holder.	≥Battery type: Panasonic lithium battery	8
With the remote control unit placed on a flat	(CR2025/1F) (supplied)
surface:	≥Battery life: Approximately 6 months under
1 Stick your thumbnail into the groove, and	normal use (at room temperature)
push the holder in the direction of the arrow,
and at the same time	Caution:
2 Pull it out in the direction of the arrow using
a tough pointed object.	≥Improper use of the battery may cause
	overheating, an explosion or ignition, resulting
Tough pointed object	in injury or a fire. Battery leakage may damage
Back side	the product.
	≥Do not expose the remote control unit to direct
	sunlight.
	≥Do not recharge, disassemble, deform or heat
	the battery.
	≥Do not put the battery in fire or water.
	≥Immediately replace used up battery.
	≥Obey local ordinances when disposing of the
	battery.
	Note:
	≥To ensure that the remote control unit is not
	lost or misplaced, use the accessory magic tape
	(“Velcro”) to secure it at a safe place.
1
2
	magic tape (“Velcro”)
2Install the battery on the battery holder.	(supplied)

Set a new battery properly with its (+) side facing up as shown in the figure.

3Insert the battery holder back into its original position.

Lithium battery (supplied)

≥Remove all oil, water, surfaces where the magic tapes are to be attached.

2

3

Battery holder CY-VHD9500U 51