Cleaning the Unit

3 Use the accessory roller cleaning paper (KV-SS03) to remove the dirt from the surfaces of all rollers.

•When wiping off the dirt, hold the rollers to prevent them from rotating. Wipe the rollers all the way around from one end to the other in the directions of the arrows shown on the diagram to the right.

•Perform the retard roller cleaning only in the left direction. If cleaned in the right direction, the roller may slip out of the proper position.

•When cleaning the rollers in the back of the bottom scanning section glass (rollers of part A), do not touch the tip of the plastic pointer (black) in the back of the unit.

Set the paper path selector as shown below. When the tip of the pointer is raised, the tip may cause an injury.

Paper path selector

The paper path selector is located on the left side of the scanner.

•The rollers to be cleaned are shaded.

•Wipe in the direction of the arrows.

Pointer

A

For roller cleaning, pull the belt in the direction of the arrow to rotate the rollers.

Belt

Retard rollers

Left side view

Other rollers

Retard rollers

37