Before You Start
■Static Electricity Damage
To prevent static electricity damage to any of the following components, touch a grounded metal surface, such as the printer's bare metal frame prior to touching the component.
•Interface connectors: network, USB, parallel, and connector for optional paper feeder
•Connector pins on the optional paper feeder
•Electrical components, connectors inside the printer
■Interface Cable
Always use a shielded interface cable. Use of an unshielded cable can result in radio interference with data.
■Power Source
The voltage level of the power source must not vary more than ±10% from the voltage level marked on the nameplate (located on the rear of the printer).
Do not use an extension cord.
Do not use a line conditioner, transient suppressor or surge protector as it may cause a printer error.
■Ventilation Space
The ventilation space is needed more than 20 mm (0.8") between the printer and a wall.
Accessories
Make sure that all accessories shown below were provided and have not been damaged. Report damage or shortages to the reseller from which the printer was purchased. The final page includes an area for recording important information such as the name of reseller, serial number, and date of purchase.
NOTE:
•Save the original carton and packing materials for future shipping and transportation of the printer. They have been specifically designed to protect the equipment
during shipment.
.
Toner cartridges
(Cyan, Magenta, Yellow, Black)
Printer includes free starter toner cartridges that yield 2,500 pages (based on 5% page coverage per color).
Color print cartridge
Black print cartridge
8
Waste toner cartridge
Power cord
Color calibration card
Keep this Color calibration card for adjusting color density.
Printer
Setup Guide (this manual)
xx |
|
xxx | |
xxxx | xx |
xxx | |
xxxxxx |
|
xxxx |
|
Warranty card
Supplies
Automatic duplex unit
Jam clear label (provided with