If the unit does not eject any recording paper during reception or copying, the recording paper has jammed. Remove the jammed paper as shown below.
1 | Open the back cover by lifting up the tabs located |
on both sides, and press the green lever to release |
the paper cutter.
2 | Pull up the corners of the transparent guide and |
remove the jammed piece of paper. |
● If the transparent guide is not pulled up, press the green lever again.
3 | Replace the transparent guide and recording paper |
roll in the proper direction, and insert the leading |
edge of the paper between the recording paper roller and the silver plate.
● Make sure that there is no slack in the paper roll.
4 | Close the back cover by gently pressing down on |
both corners of the cover. |
● A message is printed.
When the recoding paper is set to the wrong side, a message is not printed. Install the recording paper correctly.
Tab
Back cover
Green lever
Transparent guide
Recording paper roller
Silver plate
Troubleshooting Care Routine and
73