1 | A | Open the back cover by lifting up the tabs located |
| on both sides. |
BInstall a recording paper roll in the unit.
●Make sure that the shiny side of the paper is facing down and there is no slack, tape, or glue residue on the paper roll.
2 | correct incorrect |
Insert the leading edge of the recording paper | |
between the recording paper roller and the silver |
plate.
3 | Close the back cover by gently pressing down on |
both corners of the cover. |
Tab
B
A
Recording paper roller
Silver plate
Start Quick
Installation
Note:
●Only use the included roll of paper or specified recording paper, or else the print quality may be affected and/or excessive thermal head wear may occur.
●The beginning of some recording paper rolls are secured with glue or tape.
Cut approximately 150mm (6 inches) from the new roll of paper prior to installation.
●To order recording paper, see page 6.
●When power cord is connected (see the next page), everytime you close the back cover a message is printed. When the recording paper is set to the wrong side, a message is not printed. Install the recording paper correctly.
Installing the paper stackerInstall the paper stacker.
Paper stacker
For Assistance, Call | 9 |
|
|