109
Setup from the Front Panel and WebSetup
Req. All Route
Yes/No [No*]
If source routing is enabled, select Yes to allow all routers on the network to
broadcast the presence of the printer to clients, enabling packets from
clients on the network to travel to the printer by any route.
Resp. All Route
Yes/No [No*]
If source routing is enabled, and Req. All Route is set to No, select Yes to
allow all routers on the network to broadcast the presence of clients to the
printer, enabling packets from clients on the network to travel to the printer
by any route.
(*=Default setting)
Network protocol setup screens are used to specify and setup TCP/IP
Ethernet, TCP/IP Token Ring, AppleTalk and IPX (Novell) network protocols.
NOTE:
•When exiting Setup menus, the printer will automatically restart if
changes have been made to Network Protocol settings.
Network Protocol Setup
To advance to the next screen, press the Enter button. Select TCP/IP Setup ,
AppleTalk Setup, or IPX/SPX Setup, depending on your network
connections.

A) When you select TCP/IP Setup:

TCP/IP Setup
Press the Enter button to view TCP/IP options.
Enable TCP/IP?
Yes/No [No*]
Select Yes if you have a TCP/IP network connected to the printer over
Ethernet cabling.
Ethernet IP Address or Token Ring IP Address
[127.000.000.001*]
Use this option to assign the printer an Ethernet or Token Ring IP address.
Press the Continue/Forward button to increment a value. Press the Cancel/
Left button to accept a value and move to the next number to be entered.
Numbers are entered from right to left. When all values have been entered,
press the Enter button to accept your selection. (*=Default setting)
Network Protocol Setup