Operating additional units
Additional handsets
Up to 6 handsets can be registered to a single base unit. Additional handsets will give you the freedom to, for example, have an intercom call with another handset while a third handset is on an outside call. See page 3 for information on ordering additional handsets.
Additional base units
Handsets can be registered to up to 4 base units, allowing you to add additional base units and extend the area in which your handset(s) can be used. If a handset moves out of range of its base unit when “Auto” is selected on base unit selection (page 48), it will look for another base unit to make or receive calls. A base unit and the handsets it communicates with is called a “radio cell”.
Note:
LCalls will be disconnected when the handset moves from one radio cell to another.
LIntercom calls and call transfers are only possible between handsets in the same radio cell.
Registering a handset to a base unit
You can register a handset to a base unit using the following method.
1Press $(centre of joystick).
2Select t, then press ,.
3Select “Registration”, then press , 2 times.
4Select a base number, then press ,. LThis number is used by the handset as
a reference only.
5Press and hold {x} on the top of the base unit for about 5 seconds, until the registration tone sounds.
LIf all registered handsets start ringing, press {x} to stop, then repeat this step.
LAfter pressing {x}, the rest of this procedure must be completed within 1 minute.
6Wait until “Enter Base PIN” is displayed, then enter “0000” (default base unit PIN), then press ,.
LIf you changed the PIN, enter it (page 32).
Note:
LWhen the handset has been registered successfully, w will stop flashing. If key tones are turned on (page 26), a confirmation tone will be heard.
Selecting a base unit
When “Auto” is selected, the handset will automatically use any available base unit it is registered to. When a specific base unit is selected, the handset will make and receive calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1Press $(centre of joystick).
2Select t, then press ,.
3Select “Select Base”, then press ,.
4Select the desired base unit number, or “Auto”, then press ,.
LThe handset starts searching for the base unit.
Cancelling a handset
A maximum of 6 handsets can be registered to a base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This
48 | Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333 |
