Panasonic NV DS 38 B

ZOOM

INDEX INDEX

SELECT

STORE

STOP

∫

OSD

COUNTER

V/REW

STILL ADV

OFF/ON

P.B.DIGITAL

DATE/

TIME

RESET TITLE

sVOLr

¥REC

MULTI/

P-IN-P

PHOTO

SHOT

START/

STOP

A.DUB

PLAY

PAUSE

FF/W

STILL ADV

ITEM

SET

615

;

VAR.

P.B.

ZOOM

15˚

ªInserting a Button-type Battery

Before using the Remote Controller, insert the supplied button-type battery.

1While pressing the Stopper 1, pull out the Battery Holder.

2Insert the button-type battery with the imprint (i) facing

upward.

3Insert the Battery Holder into the Remote Controller.

≥When the button-type battery is weak, replace it with a new CR2025 batt ery.

(A battery is normally expected to last about 1 year. However, it depends on

operation frequency.)

≥Make sure to match the poles correctly when inserting the battery.

.........................................................................................................................

WARNING

“THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE NUMBER

CR2025 MANUFACTURED BY PANASONIC).

IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR DISCHARGE.

IT MUST THEREFORE ONLY BE FITTED IN EQUIPMENT DESIGNED

SPECIFICALLY FOR ITS USE.

REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE AND

MANUFACTURER.

THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THE

ORIGINAL BATTERY, WITH THE CORRECT POLARITY CONNECTIONS

OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE IT

FOR ANY OTHER PURPOSE. IT SHOULD BE DISPOSED OF IN WASTE

PRODUCTS DESTINED FOR BURIAL RATHER THAN INCINERATION.”

.........................................................................................................................

~~~~~~~~~~~~~~~~~~~~~~~~~

ªUsing the Remote Controller

1Direct the Remote Controller to the Remote Control Sensor

of the Movie Camera and press an appropriate button.

≥Distance from the Movie Camera:Within approximately 5 metres

≥Angle:Within approximately 15o in the vertical and horizontal directions

from the central axis

≥The above operating ranges are for indoor use. Outdoors or under strong

light, the Movie Camera may not operate properly even within the above

ranges.

≥Within a 1-metre range, you can also use the Remote Controller on the side

(the [MENU] Button side) of the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used simultaneously, they can be operated

individually by selecting different Remote Controller Modes.

≥If the Remote Controller Mode of the Movie Camera and that of the Remote

Controller do not match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [OTHER FUNCTIONS] Sub-Menu to the desired

Remote Controller Mode. (l 13)

Setup on the Remote Controller:

[VCR1]:Press the [D] Button and [∫] Button simultaneously.1

[VCR2]:Press the [E] Button and [∫] Button simultaneously.2

≥When the battery in the Remote Controller is replaced, the mode is

automatically reset to [VCR1] Mode.