Panasonic PODV7CWNS/PODV7CPNS DO NOT use a strong solvent or cleanser!

- 7 -

3. Open the access door on the bottom of the wall mount

by loosening the screw nearest the mounting plate.

4. Attach the wires from the wall to the connector provided.

using the wiring color code chart as a guide.

5. Once all wiring connections are made, place the wires

inside the wall mount bracket and close the access door.

Secure with the screw removed earlier.

1. Open the access door on the bottom of the wall mount by

loosening the screw nearest the mounting plate.

All RHW75 and RHP75 units include an optically clear

polycarbonate dome. The dome is an optical device and

should be handled with extreme care. Leave protective lm

on dome until product is fully assembled and installed. Even

though the dome is virtually unbreakable, it can be easily

scratched.

Clean only with a clean cotton cloth and warm water.

DO NOT use a strong solvent or cleanser!

Access panel

2. To attach trim ring align pins with keyhole slots and turn

clockwise about ½" (12mm). Secure (3) screw or use (3)

security screws and security tool provided.

A wall mount bracket comes standard with this unit, and

a template is included to use as a guide for mounting the

bracKet to a wall.

1. Choose the desired location for installation and mark

the drill holes using the template. Screw (2) bolts (not

provided) about ¾ of the way into the (2) top holes. Run

approximately 8 of wiring out of the wall.

2. The wall mount bracket provided with the FDW7 includes

a location for conduit entry. If you wish to install conduit to

the bracket remove the conduit hole plug. Install tting from

below the wall mount and secure with conduit nut from

inside the bracket.

NOTE: Be sure the hardware and the mounting

surface can support the weight of the

wall mount bracket plus the weight of the

housing and drive unit. The load will be

subjected to vibration from the camera

motor and wind.