Basic Operation
ENGLISH35
Powering up the projector
# Connect the supplied power
cable. (220 V-240 V, 50 Hz/60 Hz)
$ Press the “ | ” marked side of the
MAIN POWER switch to turn on
the power.
The power indicator lamp on the projector will
flash in red. After a short period, the indicator
will illuminate and the projector will enter
standby mode.
% Press POWER ON “ | ”.
The power indicator lamp illuminates in green
and soon the image is projected on the screen.
Note
If the projector is powered up at about 0 °C, a
warm-up period of approximately 5 minutes may
be necessary to start projection. The temperature
monitor (TEMP) lamp lights up during the warm-up
period. When the warm-up is completed, the
temperature monitor (TEMP) lamp turns off and the
image is projected on the screen.
If the temperature of the operating environment is
low and warm-up takes more than 5 minutes, the
projector will judge that a problem has occurred
and the power will be turned off automatically. If
this happens, increase the temperature around the
projector so that it is 0 °C or higher, and then turn on
the MAIN POWER switch and the POWER ON “ | ”
switch once more.
# $ *
Making adjustment and selection
& Roughly adjust the focus of the
lens. (p. 37)
( Select and set the projection
scheme. (p. 76)
) Select the input signal by
pressing the input selector
button to toggle through RGB1,
RGB2, DVI-D, VIDEO, S-VIDEO
and AUX. (p. 43)
The AUX button is disabled when an optional
input module is not connected.
* Adjust the tilt of the main unit in
front and rear or right and left.
(p. 20)
+
Adjust the shift. (p. 37)
- Press AUTO SETUP if the input
signal is RGB signal. (p. 44)
. Fit the image size to the screen
size. (p. 37)
/ Adjust the focus. (p. 37)
0 Display the zoom adjustment
menu again and adjust the zoom
to fit the image size to the screen
size. (p. 37)
) %
-
-, +-0%
)
&, /
-
+
.
(
(