15
Turning the power ON and OFF
Always be sure to follow the procedure given below to turn the projector power on and off.
〈Turning the power on 〉〈
Turning the power off 〉
• The projector will continue to draw approximately 13 W of power when it is in standby mode, even
after the cooling fan has stopped.
•The lamp cooling fan will continue to operate for approximately five minutes after the power is turned off.
At the same time, the self-diagnosis display “FC” will blink.
Do not disconnect the power cord from the power outlet or do not open any circuit breakers
while the cooling fan is still operating.
• When projecting a picture for the first time after setting up the projector, first press the LENS button on
the remote control unit or the projector operating panel, and then use the control level buttons (+ and -)
to adjust the basic focus.
• Turning on the power at an ambient temperature of about 0 °C may require a warm-up time of
approximately five minutes to start projecting a picture.
Codes such as “C1, C2 or C3” will appear in the self-diagnosis display during the warm-up.
After the warm-up, the self-diagnosis display will turn off and the projector will project a picture.
• If the ambient temperature is too low and the warm-up time exceeds five minutes, the power will
automatically be turned off as an abnormal condition. In this case, increase the ambient temperature to
0 °C or higher and then perform the operations “Main power ON Standby ON” again.
Main power ON
1
Press the [ ] side of the MAIN POWER switch at
the front of the projector.
(The projector will change to standby mode.)
Wait about 3 seconds
Standby ON
2
Press the POWER button on the remote control
unit or on the projector operating panel.
Picture projected3
A picture will then be projected.
After about 20 seconds
Standby OFF
1
Press the POWER button on the remote control
unit or on the projector operating panel.
Main power OFF2
Press the [ ] side of the MAIN POWER switch at
the front of the projector.
(The power will then turn off.)
Wait about 5 minutes
While projecting a picture
(The power indicator will become red)
(The power indicator is green)
(The power indicator will become red from
green after the cooling fan has stopped)
(The power indicator will become green)
NOTE