28 RQT9777
Depending on your preference, It is possible to turn off the
3D surround effect and the clear-mode dialog effect.
While pressing and holding [SOUND]
on the remote control, press and
hold [VOL i] on the main unit for
more than 4 sec.
While the setting is displayed, press
[SOUND] to change the setting.
≥The setting changes each time [SOUND] is pressed.
≥The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥This setting will be reset to on when the main unit is turned
off.
≥When off is selected, the dialog effect level cannot be
adjusted.
You can turn off dimmer mode and keep the LED
indicators bright.
While pressing and holding [INPUT
SELECTOR] on the remote control, press
and hold [sVOL] on the main unit for
more than 4 sec to turn off Dimmer mode.
≥The indicator for the current condition will turn brighter.
≥The setting is maintained until it is changed again.
≥Default setting of this function is on.
To turn on dimmer mode, repeat the operation above.
After performing the operation, the indicator for the current
condition will be dim.
∫Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on this
system and the remote control.
Preparation
≥Turn off all other Panasonic products.
≥Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at the main unit’s
remote control sensor.
2 Press and hold [MUTE] and [ ] on the remote
control for more than 4 sec.
≥All the indicators will blink for 10 sec when the code of
this system is changed.
≥The setting is maintained until it is changed again.
≥If the main unit does not operate after changing the code,
repeat steps 1 and 2.
≥To change the remote control code to code 1, repeat the
steps above, but replace [] with [INPUT SELECTOR].
∫To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, it is possible to reduce the dialog enhancing
effect as follows:
While pressing and holding [SOUND] on the
remote control, press and hold [sVOL] on the
main unit for more than 4 sec.
≥All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
To reset the setting, return to the factory preset. (>29)
∫To turn off the volume limitation
If a state of the lowered volume disturbs you every time
the main unit turns on, for example, it is possible to turn off
this function as follows:
While pressing and holding [MUTE] on the remote
control, press and hold [VOL i] on the main unit
for more than 4 sec.
≥All the indicators will blink once when the volume limitation
is turned off.
To reset the setting, return to the factory preset. (>29)
Using the Dolby Virtual
Speaker effect
“STANDARD” indicator blinks:
3D surround effect and clear-mode
dialog effect is on.
“STEREO” indicator blinks:
3D surround effect and clear-mode
dialog effect is off.
Dimmer mode
Others
SC-HTB370PPC_RQT9777-1P_mst.book Page 28 Tuesday, January 29, 2013 11:48 AM