Getting started
RQT9660 17
Connect the speaker cables.
≥Insert the wire fully, taking care not to insert beyond the wire insulation.
≥Place the speaker that is connected with the speaker cable with a red connector on the observers’ right, and connect with
the speaker cable with a white connector on the observers’ left.
To prevent the speakers from falling, it is recommended, as an additional
protection measure, to attach the speakers to the wall or table with a fall
prevention cord (hereafter “cord”).
≥Consultation with a qualified installation specialist concerning the appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support is recommended (>11, 13). Improper attachment may result in damage to
the wall and speakers, and personal injury.
≥Use a cord that is capable of supporting over 10 kg (22.05 lbs) (with a diameter of about 1.5 mm (1/16q)).
≥Keep the screws out of reach of children to prevent swallowing.
≥Make sure that the slack of the cord is minimal.
Additional speaker fall prevention measures
When attaching the speakers to a wall
ACord§BScrew eye CWall DWall-mounted speakers
§ If the cord cannot be threaded through the holes, try bending the cord in 2 locations, about
10 mm (13/32q) apart from the tip, at an angle of 45o (as illustrated above).
Insert the
wire fully.
r: White
s: Blue line
Press into the groove.
Push
Back of the base
Horizontal placement
Vertical placement
SC-HTB550_RQT9660-1P_mst.book Page 17 Monday, March 5, 2012 11:03 AM