Operations
RQT9660 27
∫Remote control code
When other Panasonic devices respond to this system’s
remote control, change the remote control code on the
main unit and the remote control.
Preparation
≥Turn off all other Panasonic products.
≥Turn on the main unit.
Change the remote control code to code 2:
1 Aim the remote control at this system’s remote
control sensor.
2 Press and hold [MUTE] and [ ] on the remote
control for more than 4 sec.
≥All the indicators will blink for 10 sec when the code of
this system is changed.
≥The setting is maintained until it is changed again.
≥If this system does not operate after changing the code,
repeat steps 1 and 2.
≥To change the remote control code to code 1, repeat the
steps above, but replace [] with [TV].
∫To reduce the clear-mode dialog effect
When the dialog does not sound natural while the volume
is set low, for example, It is possible to reduce the dialog
enhancing effect as follows:
Press and hold [TV] on the remote control and followed by
[sVOL] on the main unit for more than 2 sec.
≥All the indicators will blink once when the clear-mode dialog
effect is reduced.
≥Even if clear-mode dialog effect is reduced, dialog effect
level is still adjustable.
∫To turn off VIERA Link “HDAVI
Control”
When “HDAVI Control” compatible equipment does not
work well with this system, for example, it is possible to
turn off this function as follows:
≥When VIERA Link is turned off the ARC function is not
available. Be sure to connect the optical digital audio
cable. (>19)
1 Press and hold [MUTE] on the remote control
and followed by [sVOL] on the main unit for
more than 2 sec.
2 After the setting has changed, turn off all the
connected devices and then turn them on
again.
≥All the indicators will blink once when VIERA Link “HDAVI
Control” is turned off.
∫To turn off the volume limitation
If a state of the lowered volume disturbs you every time
this system turns on, for example, it is possible to turn off
this function as follows:
Press and hold [MUTE] on the remote control and
followed by [VOL r] on the main unit for more than 2 sec.
≥All the indicators will blink once when the volume limitation
is turned off.
The settings of the clear-mode dialog effect, VIERA Link
“HDAVI Control”, and the volume limitation remain intact even
if you switch this system to standby mode. To turn these 3
functions back on, this system must be set back to the factory
preset. (>28)
Others
The following settings are unnecessary under
general usage conditions of the system.
RQT9660~Body_mst.fm Page 27 Monday, March 5, 2012 12:23 PM