6
RQT9584
How you set up your speakers can affect the bass and the sound field.
Note the following points:
≥Place speakers on flat secure bases.
≥Keep your speakers at least 10mm (13/32q) away from the system for
proper ventilation.
≥Placing speakers too close to floors, walls, and corners can result in
excessive bass. Cover walls and windows with thick curtains.
≥For optional wall mount, refer to page 19.
Setup example (“Surround layout (Recommended)”: Standard
surround placement)
Place the front, center, and surround speakers at approximately the same
distance from the seating position. The angles in the diagram are
approximate.
§1 Position with at least 5 cm (2q) of space on all sides for proper
ventilation.
§2 Place it on a rack or shelf. Vibration caused by the speaker can
disrupt the picture if it is placed directly on the TV.
§3 Position it to the right or left of the TV, on the floor or a sturdy shelf so
that it will not cause vibration. Leave about 30cm (1113/16q) from the
TV.
Depending on the room layout, you may like to use all the speakers at the
front (“Front layout (Alternative)”) (B8, Easy setup).
Notes on speaker use
≥Use only supplied speakers
Using other speakers can damage the unit, and sound quality will be
negatively affected.
≥You can damage your speakers and shorten their lifespan if you play
sound at high levels over extended periods.
≥Reduce the volume in the following cases to avoid damage:
–When playing distorted sound.
–When the speakers are reverberating due to a record player, noise
from FM broadcasts, or continuous signals from an oscillator, test
disc, or electronic instrument.
–When adjusting the sound quality.
–When turning the unit on or off.
If irregular coloring occurs on your TV
The center speaker is designed to be placed close to a TV, but the picture
may be affected on some TVs and setup combinations.
If this occurs, turn the TV off for about 30minutes.
The demagnetizing function of the TV should correct the problem. If it
persists, move the speakers further away from the TV.
Turn off all equipment before connection and read the appropriate
operating instructions.
Do not connect the AC power supply cord until all other
connections are completed.
Pay attention to the type of speaker and the connector color when you
place the speakers.
Main unit (rear)
Connect to the terminals of the same color.
Use of the speaker cable stickers is convenient when making cable
connections.
Speakers (rear)
Insert the wire fully, taking care not to insert beyond the wire insulation.
i: White
j: Blue line
≥Be careful not to cross (short circuit) or reverse the polarity of the
speaker wires as doing so may damage the speakers.
Use an FM outdoor antenna if radio reception is poor.
step 1 Positioning
Caution
≥The main unit and supplied speakers are to be
used only as indicated in this setup. Failure to do
so may lead to damage to the amplifier and/or the
speakers, and may result in the risk of fire.
Consult a qualified service person if damage has
occurred or if you experience a sudden change in
performance.
≥Do not attempt to attach these speakers to walls
using methods other than those described in this
manual.
120°
60°
Center speaker§2
Front speaker
(left)
Subwoofer§3
Surround
speaker (left)
Surround
speaker (right)
Front speaker
(right)
Main unit§1
step 2 Connections
1Speaker connections
2Radio antenna connection
FM ANT
(75 )
Main unit (rear)
Affix this end of the antenna to a
wall or pillar where the reception is
best.
FM indoor antenna
(supplied)
SC-XH170 PPC_eng.book 6 ページ 2011年11月25日 金曜日 午前10時43分