Loading Copy Paper
10
1Set the power switch to on ( I ).
•“ ” will flash on the Multi-Copy/Error
Indicator when copy paper has run out.
•The screen will move to home position and
stop.
2Push the door open button and open the
printer door.
•If there is any copy paper rema ining in the
copy paper compartment, remove it.
3
Open
the printer door
to
position B
and load
the copy paper roll with
smooth side facing
up
, then move
the printer door
to
position A
to
prevent paper roll from falling.
(Loosen about 15 cm as shown and load it.)
Note
Use copy paper roll with a core diameter
of 25.4 mm (1 inch) or more. Using a copy
paper roll with a smaller core could cause
paper jams.
4Pass the paper over the paper feed roller and
under the cutter cover, then through the output
port about 4 cm.
5Close the printer door securely, using two
hands.
Note
•Once the door is closed, paper will feed and
automatically cut. Remove and discard the
small piece of paper.
Load a new roll when:
• Red bands become visible at the edge of the copy
paper.
• The Multi-Copy/Error Indicator flashes “ ” even if
the printer door is closed properly.
Loading Copy Paper
PUSH OPEN
POW
E
R
Copy paper
compartment
PUSH OPEN
Door
Open
Button
A
B
Smooth side
Wrong direction
About
15 cm
Paper feed
roller
Cutter cover
About 4 cm