■Setup Procedures
Set up the baud rate and parity check mode for the controller while observing the LED on the front panel.
Menu |
| Setup Menus |
|
| Parameter Selection (default*) | |
LED Display | Reading | Function |
| |||
Selection |
|
| ||||
|
|
|
|
| ||
|
|
|
| CAM |
| |
|
| Setup | Initial |
| LED prompts you to enter pass- | |
|
| Display |
| word | ||
|
|
| SET | |||
|
|
|
|
| ||
No |
|
|
|
| Enter a | |
|
|
|
|
| ||
|
| Administrator | Authorization |
| press CAM (12345*) | |
OK |
| Password |
|
| ||
blinking | Prompt |
|
|
| ||
|
|
|
| SET | ||
|
|
|
|
| ||
|
|
|
| Press |
| |
Move Joystick |
| Baud Rate | twice | (1) 2 400 (2) 4 800 (3) 9 600* | ||
Speed |
| |||||
UP and down |
| |||||
(bps) | CAM | (4) 19 200 | ||||
to select |
|
| ||||
|
|
|
|
| ||
L | R |
|
| SET |
| |
|
|
|
|
| ||
DOWN |
|
|
| MON |
| |
UP |
| Parity | Parity Check |
| (1) None* (2) Even | |
|
|
| ||||
L | R |
|
|
|
| |
|
|
|
| ESC |
| |
●Administrator Authorization
1.Press the CAMERA (ENTER) button while [SEtUP] is displayed. The [- - - -
2.Enter a password using the numeric buttons, then press the CAMERA (ENTER) button.
The default setting is [12345].
3.If the password entered is valid, [SPEED] appears. If password entry failed, the menu returns to [SEtUP].
Note: Selecting a slower rate (e.g., 2 400 bps) will delay the response time (e.g., the time until an acti- vated alarm is reset).
3.Press the CAMERA (ENTER) button to validate the selection.
4.Press the CLEAR(ESC) button to return to the [SPEED] menu.
●Baud Rate
In this menu, the communication speed (bps: bits per sec- ond) is selected. The communication speed should match that of the
1.Display [SPEED], and press the CAMERA (ENTER) button twice.
2.Select a parameter entering a
The default setting is 9 600 bps.
(1)2 400: 2 400 bps
(2)4 800: 4 800 bps
(3)9 600: 9 600 bps
(4)19 200: 19 200 bps
●Parity
In this menu, the parity check mode is selected.
1.Display [PrtY] and press the CAMERA (ENTER) button twice.
2.Select a parameter with the joystick. The default setting is None.
n:None
E:Even parity
3.Press the CAMERA (ENTER) button to validate the selection.
4.Press the CLEAR(ESC) button to return to the [SPEED] menu.
Note: The baud rate and parity check mode of the WJ- SX850 and the controller must be the same, otherwise data communications will not function.
74
