5
Hotwire 8610 DSLAM Components
99-16311
TM
TM
STACK
POSITION
2
36
5
4
1
AC
INPUT
1
2
3
ESDESD
48VDC CLASS 2
OR LIMITED
PWR SOURCE
48V
A
RTN
ABB
AB
DC FUSES
T4A, MIN. 48V PWR
A
ALM
FAN
B
OUTIN SERIAL ALM INTF MCP/1 23
MCP/
DSL
MANAGEMENT 10 BASE T
8610
MCP
8000
SYSTEM
OK
Alrm
Test
TX
RX
Coll
ETHERNET
SYSTEM
OK
Alrm
Test
TX
RX
Col
1
2
3
4
ETHERNET
DSL PORT
RADSL
8546
The Hotwire 8610 DSLAM consists of the following components:
HHotwire 8610 DSLAM base chassis
Hotwire 8610 DSLAM is a 3-slot chassis designed to house one MCP card in the
first slot and up to two DSL cards in the remaining slots. Since the MCP card in the
8610 system can provide management connectivity for up to five other 8610
DSLAMs, these other systems can use the first slot for a DSL card, thus housing
up to three DSL cards.
HOne Management Control Processor (MCP) card
The Hotwire 8610 DSLAM requires one MCP card mounted in Slot 1 of the base,
or first, chassis in a stack. The MCP card is a processor card that administers and
provides diagnostic connectivity to DSL cards in from one to six 8610 DSLAMs. It
acts as a mid-level manager and works in conjunction with an SNMP network
management system, such as HP OpenView, via its LAN port. It gathers
operational status for each of the DSL cards and responds to the SNMP requests.
It also supports a serial port for local terminal access.
HAt least one Digital Subscriber Line (DSL) card
The 8610 DSLAM requires at least one DSL card. Each DSL card contains a
number of DSL ports (depending on model), Ethernet interface circuitry, and a
processor. The processor controls the modems and forwards the packet traffic to
and from the Ethernet and DSL interfaces.
NOTE:
You must order the MCP and DSL cards separately. They are not provided with the
chassis.