ParkerVision WR3000 manual Refer to the chapter on wireless LAN for more information

20

®

WR3000 4-Port Wireless DSL/Cable Router

Set up your wireless LAN using the wizard screen below.

WIZARD

Wireless LAN Setup
ESSID	Wireless
Choose Channel ID	Channel-06 2437MHz	or Scan
WEP Encryption	Disable

64-bit WEP: Enter 5 ASCII characters or 10 hexadecimal characters (”0-9”, “A-F”) for each Key (1-4).

128-bit WEP: Enter 13 ASCII characters or 26 hexadecimal characters (”0-9”, “A-F”) for each Key (1-4). Select one WEP key as an active key to encrypt wireless data transmission

ASCII Hex

Key 1

Key 2

Key 3

Key 4

Back Next

LABEL

ESSID

DESCRIPTION

Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN. If you change this fi eld on the WR3000 Wireless Router, make sure all wireless stations use the same ESSID in order to access the network.

Choose	To manually set the WR3000 Wireless Router to use a channel, select a channel from the
Channel ID	drop-down list box. Open the Channel Usage Table screen to make sure the channel is not
	already used by another AP or independent peer-to-peer wireless network.
	To have the WR3000 Wireless Router automatically select a channel, click Scan instead.
Scan	Click this button to have the WR3000 Wireless Router automatically scan for and select a
	channel with the least interference.
WEP	Select Disable allows all wireless computers to communicate with the Wireless Routers
Encryption	without any data encryption.
	Select 64-bit WEP or 128-bit WEP to allow data encryption.

Refer to the chapter on wireless LAN for more information.