|
| TABLE OF CONTENTS |
|
| Section | Page | |
1.0 | Warranty Information ............................................................. | 2 | |
| 1.1 | Warranty Statement |
|
| 1.2 | FCC Information |
|
| 1.3 | Service Information |
|
2.0 | General Information............................................................... | 4 | |
2.1Features
2.2General Product Description
3.0 | Configuration ......................................................................... | 5 | |
| 3.1 | DIP Switch Configuration |
|
| 3.3 | Rear Interface Cards Configuration |
|
4.0 | Installation .......................................................................... | 34 | |
4.1The Model 1001R14 Rack Chassis
4.2Installing the Interface Driver Board
4.3Installing the 2701RC Into the Rack Chassis
4.4Connecting to a DTE Device
4.5Connecting to a DCE Device
4.6Connecting the E1 Interface
4.7Connecting dual Coax BNC (75ohm)
5.0 Operation ............................................................................. | 36 |
5.1LED Descriptions
5.2Loop (V.54 & Telco) Diagnostics
5.3Bit Error Rate (V.52) Diagnostics
Appendix A - Specifications ........................................................ | 41 |
Appendix B - Cable Recommendations...................................... | 42 |
Appendix C - Factory Replacement Parts and Accessories ...... | 43 |
Appendix D - E1 Interface Pin Assignments .............................. | 44 |
Appendix E - DTE Interface Pin Assignments ............................ | 45 |
1.0 WARRANTY INFORMATION
Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact Patton Electronics Technical Services at (301)
1.1 WARRANTY STATEMENT
Patton Electronics warrants all Model 2701RC Series components to be free from defects, and will at our option repair or replace the product should it fail within one year from the first date of shipment. This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse, or unauthorized modification. This product contains no serviceable parts; therefore the user shall not attempt to modify the unit in any way. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above. Under no condition shall Patton Electronics be liable for any damages incurred by the use of this product. These damages include, but are not limited to, the following: lost profits, lost savings and incidental or consequential damages arising from the use of or inability to use this product. Patton Electronics specifically disclaims all other warranties, expressed or implied, and the installation or use of this product shall be deemed an acceptance of these terms by the user. In the event the user detects intermittent or continuous product malfunction due to nearby high power transmitting radio frequency equipment, the user is strongly advised to use only data cables with an external outer shield bonded to a metal or metalized connector.
1.2 FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communi- cations. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. If this equipment does
1 | 2 |