Pelco C2506E, C2525, C2525E manual

C934M-F (7/99)C2506/C2525Pre-Wired Interconnecting Cables

®

IMPORTANT SAFEGUARDS AND WARNINGS

Prior to installation and use of this product, the following WARNINGS should be observed.

1. Installation and servicing should be done by qualified service and installation personnel only.

2. Installation should be done in accordance with all local and national electrical and mechani-

cal codes using only approved materials.

The product and/or manual may bear the following marks:

Please thoroughly familiarize yourself with the information in this manual prior to installation and

operation.

DESCRIPTION

The C2506 and C2525 are pre-wired cables used to connect Pelco’s CX9000 Series Coaxitron®

receiver with Pelco’s SB1900, SB2500, SB2600, and SS2000 Series domes and Legacy® Series

pan and tilts in indoor applications only. The C2506E and C2525E are used with CX9000 Series

receivers and Legacy® Series pan and tilts in outdoor applications.

Models

C2506 Indoor, 6-foot (1.8 m), pre-wired interconnecting cable (UL)

C2506E Same as C2506 but for outdoors

C2525 Indoor, 25-foot (7.6 m), pre-wired interconnecting cable (UL)

C2525E Same as C2525 but for outdoors

INSTALLATION

1. Connect the male 37-pin CPC connector to the Coaxitron® receiver.

2. Connect the female 37-pin CPC connector to the dome or pan and tilt unit.

3. Use the controller to perform the following functions (if applicable) and verify each operates

correctly:

•Pan left • Zoom tele • Preset operation

•Pan right • Iris open • Camera power

•Tilt down • Iris closed • Enclosure power

•Tilt up • Focus near • Camera sync

•Zoom wide • Focus far

Installation is complete when all the above functions operate correctly. If they do not, refer to the

Troubleshooting

section.

TROUBLESHOOTING

1. If any of the functions do not operate correctly, check the cable wiring (refer to Figure 1).

If the pan and tilt functions operate backwards (for example, “tilt up” actually tilts down and

“pan right” actually pans left), pins 3 and 7 for pan and pins 5 and 6 for tilt are reversed. You

can correct the problem in the field with a CPC pin/socket extracting tool by exchanging the

reversed function. If you lack the necessary tool, contact Pelco for a return authorization

number to exchange the cable.

2. If the connections are loose, tighten the lock ring on the CPC connectors.

3. Check the Coaxitron® receiver to determine if it is operating correctly.

This symbol indicates that dangerous voltage

constituting a risk of electric shock is present

within this unit.

This symbol indicates that there are important

operating and maintenance instructions in the

literature accompanying this unit.

CAUTION:

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

3500 Pelco Way,

Clovis, CA 93612-5699

USA

In North America & Canada:

Tel (800) 289-9100

FAX (800) 289-9150

International Customers:

Tel (1-559) 292-1981

FAX (1-559) 348-1120